How to properly install the hydraulic jack filter
June 13, 2018
Learn hydraulic jacks knows, hydraulic jacks have a filter. So how do you install a filter when you get a hydraulic jack? Today, we introduced the correct method for installing the hydraulic jack filter.
1. Pay attention to the direction of the flow marked on the filter housing. Do not install it in reverse. Otherwise, the filter element will be destroyed and the hydraulic system will be contaminated.
2. When the filter differential pressure indicator shows a red signal, clean or replace the filter element in time.
3, the installation position of the filter in the hydraulic jack mainly depends on its use. In order to filter the dirt from the hydraulic oil source and protect the hydraulic pump, a rough filter is installed in the suction pipe. In order to protect the key hydraulic components, a fine filter is installed in front of it. The rest should be installed in the low pressure circuit piping.
4. When the screen filter is installed on the oil suction pipe of the hydraulic pump, the bottom surface of the mesh filter cannot be too close to the suction port of the hydraulic pump. The reasonable distance is 2/3 of the filter height, otherwise, the suction will It will not work well. The filter must be completely immersed below the oil level so that the oil can enter the oil tube from all sides, and the filter mesh is fully utilized.
5, cleaning metal woven square hole mesh filter element, the brush can be used in brushing the oil filter, and cleaning high-precision filter element, you need to use ultra-clean cleaning liquid or cleaning agent. Wire braided special meshes and stainless steel fiber sintered felts can be cleaned by ultrasonic cleaning or reverse flow. The filter element should block the filter port during cleaning to prevent dirt from entering the filter cavity.